Showing posts with label Pragel. Show all posts
Showing posts with label Pragel. Show all posts

Monday, June 3, 2013

Custom Bathroom Unit with Adils legs


Materials: 8 x ADILS Black Legs, 1 PRÄGEL Countertop

Description: I made a custom Bathroom Unit out of ADILS legs and PRÄGEL countertop.

Description:
I customized the PRÄGEL into 2 Units that fitted the width of the niche. I also made them trapezoids with one of the sides longer than the other.

I then drilled holes in the PRÄGEL for the pipes from the sink.



The nice things with the ADILS is that they are made of hollow metal, so they are easy to cut. You just pop out the plastic feet off the leg, cut it to the desired length, and pop the plastic feet back on.

The feet can also be adjusted to fine-tune the height of the legs.

I screwed the legs under the two PRÄGELs and put them on top of each other. I also used some L-brackets to fasten the PRÄGEL to the wall.

Ingredients:
8 x ADILS legs
1 x PRÄGEL countertop
2 x L-shaped brackets

Tools used:
1 Hand Saw for cutting wood (For cutting the PRÄGEL)
1 Hand Saw for cutting the metal ADILS legs
1 Hole Saw for cutting the holes for the pipings
1 Screwdriver to screw the ADILS legs on the PRÄGEL and the brackets to the wall.

~ Stein, Norway

Saturday, May 25, 2013

T Kitchen Island/Dining Table


Materials: Expedit Shelving unit, Pragel Countertop, Galant Tabletop, Vika Byske legs, wood and hardware

Description: 1. Attach the countertop to the bookshelf using Gorilla Glue and L-brackets. I used 8 brackets total: 1 on each short side and 3 on each long side.



2. Drill holes into the countertop.
I taped the area around the hole to prevent the laminate from shattering. I also started with a very small drill bit and gradually increased the size of the hole.

All the while, I had the drill in reverse to further prevent unwanted damage to the laminate. The metal attachments on the underside of the table will simply sit in the holes (about .5" deep). I initially thought the diameter of the metal pieces was 1.5 inches. It turns out the diameter was slightly larger than that, so I had to twist the drill around in a way that would make a real carpenter cringe.


3. Attach legs to the other end of the table.
I cut a 2x6 to about 24" and painted what would be the underside. I used the same 1.5" spade drill bit to put in holes (about .5" deep) into the wood. I then drilled a .25" hole so that I could run a bolt through the wood and screw it into the metal pieces on the table. I'd recommend starting with the small hole (I didn't, and what I did to get things to line up right would've made that carpenter cringe again).

Once the wood is attached to the table, just drill small pilot holes and screw the legs onto the wood.

4. Put it together. Have the metal sit in the holes on the counter (mine is pretty snug), and adjust the legs on the other end until everything is level.

5. Throw a party.

~ Glenn, Washington, DC